NC-UVA3MAX Scraper replacement

Proper NC-UVA3MAX Scraper replacement​ keeps the Epson I3200-U1HD printhead clean on this desktop UV printer. The NC-UVA3MAX prints up to 297×420 mm, handles media up to 90 mm thick, runs CMYK+W+V at 1200 dpi, uses Future RIP, 140W, AC 220/110V, eco UV ink, 25–28°C / 35–65% RH, 64 kg . The scraper wipes residual UV ink, dust and debris from the nozzle plate during maintenance cycles. A worn, hardened or ink-caked blade stops cleaning properly and can leave streaks, missing nozzles or even scratch the printhead. Swapping in a genuine Nocai scraper restores consistent wiper action.

Preparation

Power off and unplug the printer. Wear nitrile gloves and prepare a screwdriver, a lint-free cloth, Nocai UV cleaning solution and a new OEM scraper. Move the carriage out by pressing the left button on the control panel so the wiper holder faces the service position. Never touch the rubber cleaning edge with bare fingers.

Remove the old scraper

Hold the wiper holder steady. Loosen the two fixing screws, pinch the side clips, then lift the old blade out of its slots. Slide the worn scraper off the holder and dispose of it in a sealed bag—UV ink residue is sticky. Check the holder, cap station and surrounding area for dried ink buildup before fitting the new part.

Install the new scraper

Take the new OEM Nocai scraper and seat it into the two card slots in the same orientation as the old one. Press until it clicks firmly into place, then refit the holder and tighten the two screws lightly—do not over-torque. Clean the surrounding area with UV-approved solution. The rubber edge must sit straight and make full contact with the nozzle line.

Test and verify

Plug the printer back in and power on. From standby, press the right button to enter the maintenance menu, select “Wiper / Scrape nozzle”, and confirm. The new scraper should travel across the nozzle plate and remove surface ink cleanly. Run a nozzle check; all channels should fire evenly with no streaks.

Post-replacement care

Inspect the scraper edge daily for ink caking or hardening. Wipe it gently with UV cleaning solution, and replace the blade every 1–3 months under regular UV ink use—sooner for heavy production. Keep the cap station dust-free and use only Nocai original scrapers and eco UV ink to protect print quality and warranty.