NC-UVA3MAX Replacement of grating sensor

Proper NC-UVA3MAX Replacement of grating sensor​ restores accurate X-axis reading on this desktop UV printer. The NC-UVA3MAX uses one Epson I3200-U1HD head, prints 297×420 mm with 0–90 mm media height, runs CMYK+W+V at up to 1200 dpi, Future RIP, 140W, AC 220/110V, eco UV ink, 25–28°C / 35–65% RH, 64 kg . The grating sensor reads the encoder strip and reports carriage position to the board. A dirty lens, misaligned slot or failed reader causes banding, ghosting, homing errors or X-position drift. Fitting a genuine Nocai sensor returns stable tracking.

Check before replacing

Power off and unplug the printer, then engage emergency stop if fitted. Move the carriage to mid-beam. First clean the sensor window and the encoder strip with a lint-free wipe and ≥99% isopropyl alcohol—ink mist often causes false faults . Reseat the connector and inspect the cable for looseness or breaks. Only proceed when the error remains after cleaning and reseating.

Remove the old sensor

Photograph the bracket, cable route, connector and strip slot position. Disconnect the sensor cable from the mainboard or intermediate plug and label it. Unscrew the old reader and lift it out gently. Note the reading direction and the gap to the encoder strip. Check the lens, cable and bracket for ink buildup, impact marks or physical damage. Do not bend the strip or touch its scale surface.

Install the new sensor

Mount the OEM Nocai grating sensor in the exact original orientation. Pass the encoder strip through the sensor slot without contact or tilt, keep the manual-specified gap, and tighten screws lightly. Reroute the cable away from the X-axis belt, carriage path and UV lamp area, then lock the connector. Confirm the strip moves freely through the slot.

Home and test

Release emergency stop, power on and run the homing sequence. The carriage should move left and right with smooth, increasing X-values and no jumps. In Future RIP, run a nozzle check, step grid and alignment pattern; measure printed size against design size. Stable readings complete the NC-UVA3MAX Replacement of grating sensor.

Post-replacement care

Wipe the sensor window and encoder strip weekly with alcohol, keep the slot dust-free, and avoid touching the scale with bare hands. Service the rail and cap station per manual, and use only Nocai original sensors and eco UV ink to protect print accuracy and after-sales support.