NC-UV0609PEIII-II ink absorber pad replacement

15 Lượt xem

Thích hợp NC-UV0609PEIII-II ink absorber pad replacement​ is necessary when the printer displays “waste ink tank full” warnings, ink pools under the capping station, or the pad becomes visibly saturated. The absorber pad collects excess ink during cleaning and printing cycles. A saturated pad can leak ink into the printer chassis, causing electrical shorts and corrosion. Replacing it restores safe waste ink management. Thực hiện theo các bước dưới đây một cách cẩn thận.

Sự chuẩn bị

Tắt nguồn máy in và ngắt kết nối cáp nguồn. Wear nitrile gloves. Place absorbent paper under the capping station. Bạn sẽ cần: a new genuine ink absorber pad (specific to NC-UV0609PEIII-II), flat-head screwdriver, nhíp, khăn lau không có xơ, và rượu isopropyl.

Removing the Old Pad

Open the front cover and locate the capping station. Slide the carriage to the maintenance position. Remove the capping station cover (usually held by clips or screws). Carefully lift the old absorber pad using tweezers. Some pads are glued; gently pry them loose. Avoid spilling accumulated ink. Place the old pad in a sealed waste bag.

Cleaning the Tray

Wipe the tray beneath the pad with lint-free wipes moistened with isopropyl alcohol. Remove all dried ink residue and debris. Check the waste ink tube for clogs – flush with alcohol if needed. Allow the tray to dry completely.

Installing the New Pad

Unfold the new absorber pad and position it into the tray, ensuring it sits flat and covers the entire bottom surface. Press down firmly to seat it. Reinstall the capping station cover and secure all clips or screws.

Testing

Kết nối lại nguồn và bật máy in. Enter the maintenance menu and reset the waste ink counter (refer to service manual for procedure). Run a cleaning cycle and observe the pad absorbing ink without overflow. Print a test pattern to confirm normal operation. If no leaks occur and the warning clears, NC-UV0609PEIII-II đã sẵn sàng để sản xuất.

Post-Replacement Care

Check the pad condition weekly during the first month. Replace again when the warning reappears (typically after 6–12 months depending on usage). Keep the waste ink tube clear to prevent backup.