NC-UV0609MAX-Ⅱ 下限リミットスイッチ交換
2026-11-15 54 ビュー
ちゃんとした NC-UV0609MAX-Ⅱ Lower limit switch replacement restores safe downward travel detection on this 600×900 mm industrial UV printer. NC-UV0609MAX-II は Epson 13200-U1 ホワイトを使用します, 13200-U1HD カラーと 11600-U1 ワニス, CMYK+LC+LM+LK+LIK+W+V を 720×600/900/1200 dpi で実行, フレキシプリント 22, 470W, AC220/110V, 負圧エコUVインク, 25–28℃ / 35–65%相対湿度. The lower limit switch guards the Z-axis or platform bottom position; a failed unit can cause over-travel, bed collision, failed homing or false zero-point errors. Fitting a genuine Nocai sensor returns reliable stopping at the lower end.
まずケーブルを確認してください
作業前にプリンターの電源を切り、プラグを抜いてください. Engage emergency stop if fitted. Open the access area near the Z-axis base or platform underside. Reseat the lower limit plug to clear oxidation, then inspect the full cable for looseness, breaks or ink contamination. 再装着後に障害が解消された場合, no replacement is needed. Proceed only when the error remains with an intact cable.
古いスイッチを取り外します
ブラケットを写真に撮る, connector and trigger plate position. センサーケーブルをメインボードまたは中間コネクタから外します. 古いスイッチのネジを外し、ゆっくりと持ち上げて取り外します. Note the actuator direction and the exact gap to the trigger plate. Check the plunger, lever or optical slot for dust, インクミスト, 新しい部品を取り付ける前の衝撃跡や動きの固着.
新しいセンサーを取り付けます
Mount the OEM Nocai lower limit switch in the same orientation and position. ネジは締めすぎずにしっかりと締めてください. プラグがロックされるまで再度差し込みます, and route the cable away from the Z screw, carriage path and drag chain. Confirm the trigger plate aligns with the detection zone; a shifted bracket changes the stop point and zero accuracy.
テストとリセット
電源を再接続してプリンターを起動します. Run the Z-axis homing routine from the panel. The platform should stop smoothly at the lower limit without slamming or passing through. If the lower-limit error clears and movement stays stable, ノズルチェックを実行してテストパターンを印刷する. Safe stopping completes the NC-UV0609MAX-II Lower limit switch replacement.
交換後のケア
スイッチ部分にほこりやインクミストが付着しないようにしてください. Inspect the cable and trigger plate monthly for slack, deformation or abrasion. Never bypass the switch or short its pins. 交換日と部品番号を記録します。; if the error recurs, check the cable, mainboard or mechanical bracket.
ノーカイ – UVプリンター専門メーカー | デジタル印刷ソリューション