NC-UV0406-VI インク吸収パッド交換

58 ビュー

ちゃんとした NC-UV0406-VI ink absorber pad replacement​ keeps the Epson I1600-U1 printheads clean during maintenance cycles. The NC-UV0406-VI is an A2 desktop UV printer with dual I1600-U1 heads, 400×600 mm flatbed, and CMYK+W/V modes. The absorber pad collects waste UV ink from cleaning, capping, and purging. Over time it becomes saturated, causing ink overflow, poor capping, and even printhead damage. Replacing the pad when needed ensures stable suction and clean nozzles.

準備

Power off and unplug the printer. ニトリル手袋を着用する. Open the cover and move the carriage to the maintenance position. Prepare a new genuine Nocai absorber pad, 糸くずの出ないワイプ, Nocai UV cleaning solution, プラスドライバー, and pliers. Photograph the waste tube routing and sensor position. Check the maintenance station area for ink leaks or hardened residue before starting.

古いパッドの取り外し

Locate the absorber pad tray under the maintenance station. Remove the screws or clips holding the tray. Gently slide out the old pad. Note the sensor position so you can reinstall it correctly. Dispose of the saturated pad as chemical waste. Inspect the tray for ink crust; 存在する場合, clean it later. Avoid touching the capping rubber with bare hands.

新しいパッドの取り付け

Clean the tray with Nocai UV cleaning solution and let it dry. Insert the new OEM pad into the tray, aligning it with the sensor and tube openings. Reinstall the tray and tighten screws lightly—do not over-torque. Reconnect any waste tubes and confirm the sensor wire is seated. Ensure the pad sits flat and the cap unit aligns with the printhead.

Counter Reset and Testing

プリンターの電源を入れます. Open FlexiPRINT or the printer driver; reset the waste ink counter if your machine has this function. Run two or three cleaning cycles, then print a nozzle test. All channels should fire evenly with no streaks or overflow. Check the pad area for leaks. When the test is clean, the NC-UV0406-VI ink absorber pad replacement​ is complete and the printer is ready for production.