NC-UVA3MAX 替代光栅传感器
2026-11-22 64 次
恰当的 NC-UVA3MAX Replacement of grating sensor restores accurate X-axis reading on this desktop UV printer. NC-UVA3MAX使用1个Epson I3200-U1HD头, 打印尺寸为 297×420 毫米,介质高度为 0–90 毫米, 运行 CMYK+W+V 的速度高达 1200 分辨率, Future RIP, 140瓦, 交流220/110V, 环保UV油墨, 25–28°C / 35–65% 相对湿度, 64 千克 . The grating sensor reads the encoder strip and reports carriage position to the board. 镜头脏了, misaligned slot or failed reader causes banding, ghosting, homing errors or X-position drift. Fitting a genuine Nocai sensor returns stable tracking.
更换前检查
关闭打印机电源并拔掉电源插头, 然后启动紧急停止装置(如果已安装). Move the carriage to mid-beam. First clean the sensor window and the encoder strip with a lint-free wipe and ≥99% isopropyl alcohol—ink mist often causes false faults . 重新安装连接器并检查电缆是否松动或断裂. 仅当清洁并重新安装后错误仍然存在时才继续.
拆下旧传感器
拍摄支架, 电缆路线, connector and strip slot position. 从主板或中间插头上断开传感器电缆并贴上标签. Unscrew the old reader and lift it out gently. Note the reading direction and the gap to the encoder strip. 检查镜头, 用于墨水堆积的电缆和支架, 撞击痕迹或物理损坏. Do not bend the strip or touch its scale surface.
安装新传感器
Mount the OEM Nocai grating sensor in the exact original orientation. Pass the encoder strip through the sensor slot without contact or tilt, 保持手册规定的间隙, and tighten screws lightly. 重新布置电缆,使其远离 X 轴皮带, 运输路径和紫外线灯区域, 然后锁定连接器. Confirm the strip moves freely through the slot.
家庭和测试
解除紧急停止, 通电并运行归位序列. The carriage should move left and right with smooth, increasing X-values and no jumps. 未来安息吧, 运行喷嘴检查, 阶梯网格和对齐图案; measure printed size against design size. Stable readings complete the NC-UVA3MAX Replacement of grating sensor.
更换后护理
Wipe the sensor window and encoder strip weekly with alcohol, keep the slot dust-free, 并避免裸手触摸秤. Service the rail and cap station per manual, 并仅使用Nocai原装传感器和eco UV墨水来保障打印精度和售后支持.
诺彩 – 专业UV打印机制造商 | 数码印刷解决方案