NC-UV0609MAX-II Замена перистальтического насоса

53 Просмотры
Правильный NC-UV0609MAX-II Peristaltic pump replacement​ restores strong cleaning suction on this 600×900 mm industrial UV printer. NC-UV0609MAX-II печатает высотой 0–180 мм., использует Epson 13200-U1 белого цвета, 13200-Цвет U1HD и лак 11600-U1, работает CMYK+LC+LM+LK+LIK+W+V с разрешением 720×600/900/1200 точек на дюйм, Мини-сервер FlexiPRINT 22, 470Вт, 220/110 В переменного тока, эко УФ-чернила отрицательного давления, 25–28°С / 35–65% относительной влажности. Its ink station integrates a wiper motor, кепка сверху, перистальтический насос и картридж для отходов. A weak pump leaves residual ink, causes dry nozzles and poor auto cleaning. Fitting an OEM Nocai pump returns reliable suction.

Подготовка

Выключить питание, отключите и проверьте заземление. Наденьте нитриловые перчатки.. Through the panel, драйвер или FlexiPRINT, park the carriage at the maintenance position. Prepare an OEM Nocai peristaltic pump, matching silicone tubes, small drivers, пинцеты, салфетки, UV cleaning solution and bracket photos. Relieve negative pressure, then label every inlet and outlet tube. Do not kink tubes or touch the printheads during setup.

Remove the old pump

Disconnect the pump cables from the board and label polarity. Loosen tube clamps, remove the inlet from the cap/wash side and the outlet to the waste bottle, then unbolt the pump head or motor bracket. Inspect rollers, silicone tube hardness, cracks and ink buildup. Replace both the pump assembly and worn tubing when suction drops, pulsates or leaks during auto cleaning.

Install the new pump

Mount the OEM Nocai pump in the original orientation and tighten the bracket evenly. Fit specified silicone tubes without twists, secure clamps, and align rotation direction per the NC-UV0609MAX-II manual. Reconnect the power cable, route wires away from the X-axis belt, carriage path and UV lamp. Confirm the inlet serves the cap station and the outlet reaches the waste cartridge or bottle.

Prime and cleaning test

Включение питания, enter standby maintenance, run manual pumping until cleaning fluid and ink flow to the waste path, then run Auto Cleaning. The system executes scraping, промывка и укупорка чернил. Распечатайте тест дюз на прозрачном носителе; все каналы CMYK+W+V должны срабатывать равномерно. If suction stays weak, recheck tubes, direction and clamps. Stable suction completes the NC-UV0609MAX-II Peristaltic pump replacement.

Уход после замены

Inspect tubes weekly for flattening, replace silicone lines per manual, and empty the waste cartridge regularly. Wipe the cap top, wiper and encoder strip, keep 25–28°C / 35–65% относительной влажности, and use only Nocai eco UV ink with original pump parts. Non-Nocai consumables void after-sales support.