NC-UVDTF60 New Machine Installation

167 Visualizações

Apropriado NC-UVDTF60 New Machine Installation​ is essential for achieving optimal Crystal Label print quality and long-term reliability. The NC-UVDTF60-PLUS is a 60 cm all-in-one UV DTF printer integrating peeling, impressão, laminação, and rewinding. This guide covers the key steps from unpacking to test printing, ensuring your machine is set up correctly and ready for production. Siga as etapas abaixo com atenção.

Desembalagem e preparação do local

Remova cuidadosamente todos os materiais de embalagem e inspecione a máquina quanto a danos de transporte. Coloque a impressora em um nível, vibration‑free floor with at least 50 cm clearance on all sides for ventilation and maintenance. Maintain an ambient temperature of 20–28 °C and relative humidity below 65 %. Evite luz solar direta e áreas empoeiradas.

Nivelamento e Conexão Elétrica

Use a spirit level to adjust the four leveling feet until the machine is perfectly horizontal. Improper leveling can cause uneven ink flow and film misalignment. Conecte o cabo de alimentação principal a uma tomada aterrada dedicada que corresponda à voltagem da impressora (220 V/50 Hz or 110 V/60 Hz). Do not share the circuit with high‑power equipment. Ligue e verifique se o painel de controle inicializa normalmente.

Film Loading and Ink Filling

Load the A‑film (release film) and B‑film (transfer film) onto their respective rollers following the film path diagram on the machine. Adjust tension knobs to keep the film flat without wrinkles. Fill the ink tanks with the supplied UV ink set (GL + KCMY + White + Varnish + Gold Varnish). Open the ink valves and run the automatic ink filling cycle from the control panel until all lines are primed.

Configuração de software e cabeçote de impressão

Instale o software RIP fornecido em um computador Windows conectado. Configurar a porta de comunicação (USB ou Ethernet) e carregue o driver de impressora correto. Perform a nozzle check from the control panel. Se algum bico estiver faltando, run the automatic cleaning cycle until all channels fire completely. Esta etapa é crítica para a qualidade de impressão.

Impressão de teste e ajuste final

Load a sample design into the RIP software and send a test print. The machine will automatically peel, print, laminate, and rewind the Crystal Label. Inspect the output for color accuracy, adhesive bonding, e nitidez das bordas. Adjust the lamination pressure and print parameters as needed. Once the test label meets your standards, the NC-UVDTF60 New Machine Installation​ is complete and the printer is ready for production.

Post‑Installation Maintenance

Agende verificações diárias dos bicos, limpeza semanal do limpador, and monthly filter replacements. Keep the film path clean and free of dust. Following these procedures maximizes uptime and ensures consistent Crystal Label quality.