NC-UV0609MAX-II Scraper replacement

37 조회수
적절한 NC-UV0609MAX-II Scraper replacement​ keeps the industrial printheads clean during maintenance cycles. The NC-UV0609MAX-II prints 600×900 mm with 0–180 mm height, uses Epson 13200-U1 white, 13200-U1HD color and 11600-U1 varnish, runs CMYK+LC+LM+LK+LIK+W+V at 720×600/900/1200 dpi, FlexiPRINT 미니서버 22, 470여, AC 220/110V, negative-pressure eco UV ink, 25-28°C / 35-65% 상대습도. The ink station includes a wiper motor, cap top, peristaltic pump and waste cartridge; the manual troubleshoots color mixing by checking whether the scraper scrapes the nozzle mirror normally during auto cleaning. Replacing a worn scraper restores even wiping and prevents banding.

준비

프린터 전원을 끄고 플러그를 뽑습니다.; 접지 확인. 니트릴 장갑을 착용하세요. Open the cover and move the carriage to the maintenance position through the panel, driver or FlexiPRINT. Prepare a new genuine Nocai scraper/wiper, 보푸라기가 없는 물티슈, 노카이 UV 세정액, tweezers and a small driver. Photograph the wiper holder, scraper angle and cable before removal.

Removing the old scraper

Release the wiper holder screw or clip and slide out the old scraper. Inspect the rubber edge for hardening, 균열, ink cake or uneven wear. The NC-UV0609MAX-II maintenance workflow supports manual scraping, auto cleaning and nozzle test; a damaged blade that cannot wipe the nozzle mirror causes residual ink and streaking. Dispose of the old blade safely because UV ink residue is sticky.

Installing the new scraper

Fit the OEM scraper in the original orientation and align its edge parallel to the nozzle plates. Tighten the holder lightly per the Nocai manual—avoid excess pressure that bends the blade or touches nozzles. Clean the cap top and surrounding ink station with UV cleaning solution. Confirm the wiper motor can drive the scraper smoothly across all heads without obstruction.

Auto clean and nozzle test

전원 켜기, run Auto Cleaning in the driver or FlexiPRINT; the system executes scraping, ink washing and capping as configured. Print a nozzle test on transparent media; all CMYK+W+V channels should fire evenly. If gaps remain, clean again and retest. When output is streak-free, the NC-UV0609MAX-II Scraper replacement​ is complete and the printer is ready for production.

Post-replacement care

Wipe the scraper edge daily with UV cleaning solution, service the cap station and encoder strip per the manual, Nocai 정품 잉크만을 사용합니다., wiper and spare parts. Non-Nocai ink voids after-sales support. Keep 25–28°C / 35–65% RH for stable wiper performance.