NC-UV0609MAX-II Peristaltic pump replacement

47 조회수
적절한 NC-UV0609MAX-II Peristaltic pump replacement​ restores strong cleaning suction on this 600×900 mm industrial UV printer. The NC-UV0609MAX-II prints 0–180 mm height, Epson 13200-U1 흰색을 사용합니다., 13200-U1HD 컬러 및 11600-U1 바니시, 720×600/900/1200dpi에서 CMYK+LC+LM+LK+LIK+W+V 실행, FlexiPRINT 미니서버 22, 470여, AC 220/110V, 음압 에코 UV 잉크, 25-28°C / 35-65% 상대습도. Its ink station integrates a wiper motor, 캡 탑, 연동 펌프 및 폐기물 카트리지. A weak pump leaves residual ink, causes dry nozzles and poor auto cleaning. Fitting an OEM Nocai pump returns reliable suction.

준비

전원 끄기, 플러그를 뽑고 접지를 확인하세요.. 니트릴 장갑을 착용하세요. Through the panel, 드라이버 또는 FlexiPRINT, park the carriage at the maintenance position. Prepare an OEM Nocai peristaltic pump, matching silicone tubes, small drivers, 족집게, 물티슈, UV cleaning solution and bracket photos. 부정적인 압력을 완화, then label every inlet and outlet tube. Do not kink tubes or touch the printheads during setup.

Remove the old pump

Disconnect the pump cables from the board and label polarity. Loosen tube clamps, remove the inlet from the cap/wash side and the outlet to the waste bottle, then unbolt the pump head or motor bracket. Inspect rollers, silicone tube hardness, cracks and ink buildup. Replace both the pump assembly and worn tubing when suction drops, pulsates or leaks during auto cleaning.

Install the new pump

Mount the OEM Nocai pump in the original orientation and tighten the bracket evenly. Fit specified silicone tubes without twists, secure clamps, and align rotation direction per the NC-UV0609MAX-II manual. Reconnect the power cable, route wires away from the X-axis belt, carriage path and UV lamp. Confirm the inlet serves the cap station and the outlet reaches the waste cartridge or bottle.

Prime and cleaning test

전원 켜기, 대기 유지 관리 시작, run manual pumping until cleaning fluid and ink flow to the waste path, then run Auto Cleaning. The system executes scraping, 잉크 세척 및 캡핑. 투명 용지에 노즐 테스트 인쇄; 모든 CMYK+W+V 채널은 균등하게 실행되어야 합니다.. If suction stays weak, 튜브를 다시 확인하세요, direction and clamps. Stable suction completes the NC-UV0609MAX-II Peristaltic pump replacement.

교체 후 관리

Inspect tubes weekly for flattening, replace silicone lines per manual, and empty the waste cartridge regularly. Wipe the cap top, wiper and encoder strip, keep 25–28°C / 35-65% 상대습도, and use only Nocai eco UV ink with original pump parts. Non-Nocai consumables void after-sales support.