NC-UV0609MAX-II grating strip replacement

23 조회수
적절한 NC-UV0609MAX-II grating strip replacement​ restores X-axis positioning on this 600×900 mm industrial UV printer. The machine prints 0–180 mm height, Epson 13200-U1 흰색을 사용합니다., 13200-U1HD 컬러 및 11600-U1 바니시, 720×600/900/1200dpi에서 CMYK+LC+LM+LK+LIK+W+V 실행, FlexiPRINT 미니서버 22, 470여, AC 220/110V, 음압 에코 UV 잉크, 25-28°C / 35-65% 상대습도. The encoder strip works as the carriage ruler; 긁힌 자국, 잉크, dust or misalignment cause ghosting, homing errors or carriage faults. Replacing it with a genuine Nocai strip returns stable readings.

준비

전원 끄기, unplug and verify grounding. 정전기 방지 장갑을 착용하세요.. Move the carriage to the middle of the beam through the panel, 드라이버 또는 FlexiPRINT. Prepare an OEM Nocai grating strip, screwdriver, 족집게, 보푸라기가 없는 물티슈, ≥99% isopropyl alcohol and photos of brackets. Do not touch the sensor or X-axis limit switch during preparation.

Remove the old strip

Loosen the top or side cover screws per the manual, then release the strip brackets. Slide the old encoder strip out of the sensor slot slowly to avoid bending it. Inspect for scratches, 잉크 미스트, grease and slack tension. If only dust or ink causes errors, clean with alcohol in one direction and retest before replacement.

Install the new strip

Fix one end of the new OEM strip, route it straight through the encoder sensor slot without twisting, then secure the other end. Adjust upper and lower screws so the strip stays centered in the sensor gap; the carriage must move without scraping the strip. Keep the strip parallel to the beam and away from printheads, cables and the UV lamp area.

Homing and accuracy test

Power on and move the carriage left or right; the control panel should show positive X-axis values that increase smoothly without jumps. 자동 청소 실행, then print a nozzle test and an alignment grid. Measure printed size against design size. If drift remains, recenter the strip and clean the sensor slot. When readings are stable, the NC-UV0609MAX-II grating strip replacement​ is complete.

교체 후 관리

Clean the encoder strip with alcohol in one direction weekly, keep the sensor slot dust-free, and avoid touching the scale with bare hands. Service rails, ink station and suction platform per the manual, use only Nocai eco UV ink and original parts, 25~28°C를 유지하세요 / 35-65% 상대습도.