NC-UVA3MAX Ink Pad Replacement

Approprié NC-UVA3MAX Ink Pad Replacement​ keeps the waste-ink system clean on this desktop UV printer. The NC-UVA3MAX uses one Epson I3200-U1HD head, prints 297×420 mm with 0–90 mm media height, runs CMYK+W+V at up to 1200 ppp, Futur RIP, 140W, CA 220/110 V, encre UV écologique, 25–28°C / 35–65% HR, 64 kilos . Pendant le nettoyage automatique, scraping and pumping, excess ink collects near the cap station and waste path. A saturated or hardened pad causes overflow, chassis contamination, odor and nozzle problems. Swapping in a genuine Nocai pad restores safe waste management.

Préparation

Power off and unplug the printer before any maintenance . Wear nitrile gloves and place a tray under the cap station. Prepare a new OEM Nocai ink pad, lingettes non pelucheuses, Solution de nettoyage approuvée par les UV, pince à épiler, a small screwdriver and absorbent paper. Move the carriage to the maintenance position from the panel. Photographiez la couverture de la station de captage, pad tray and waste tube before removal so nothing is reassembled wrongly.

Remove the old pad

Open the cap-station cover and locate the waste pad beside or under the capping area. Lift the old pad gently with tweezers—do not squeeze it, because trapped UV ink may leak. If your unit routes waste to a bottle instead of a sponge pad, disconnect the tube and empty or replace the bottle. Seal all waste in a plastic bag for proper chemical disposal.

Clean and install the new pad

Wipe the tray with cleaning-solution-moistened wipes to remove dried ink and debris. Check the waste tube for blockage and flush it if needed, then let the tray dry. Fit the OEM pad flat across the whole tray bottom without folds or gaps. Reinstall the cap-station cover, reconnect the waste tube and make sure the tube has no kinks near the carriage path.

Tester et vérifier

Power on and enter the maintenance menu. Run manual pumping, then Auto Cleaning so the system scraps, washes and caps the head. Watch the waste path for leaks. Imprimer un test de buses sur support transparent; all CMYK+W+V channels should fire evenly with no streaks. No overflow means the NC-UVA3MAX Ink Pad Replacement​ is complete.

Soins post-remplacement

Inspectez le tampon ou la bouteille chaque semaine au cours du premier mois., puis mensuellement. Gardez la pièce à 25-28°C / 35–65% HR, clean the cap station regularly, and use only Nocai original pads and eco UV ink to protect print quality and after-sales support.