NC-UV0406-VI ink absorber pad replacement

59 Vues

Approprié NC-UV0406-VI ink absorber pad replacement​ keeps the Epson I1600-U1 printheads clean during maintenance cycles. La NC-UV0406-VI est une imprimante UV de bureau A2 avec deux têtes I1600-U1, 400Plateau ×600 mm, et modes CMJN+W/V. The absorber pad collects waste UV ink from cleaning, capping, and purging. Over time it becomes saturated, causing ink overflow, poor capping, and even printhead damage. Replacing the pad when needed ensures stable suction and clean nozzles.

Préparation

Éteignez et débranchez l'imprimante. Portez des gants en nitrile. Ouvrir le capot et déplacer le chariot en position de maintenance. Prepare a new genuine Nocai absorber pad, lingettes non pelucheuses, Solution de nettoyage UV Nocai, un tournevis cruciforme, et des pinces. Photograph the waste tube routing and sensor position. Check the maintenance station area for ink leaks or hardened residue before starting.

Retrait de l'ancien tampon

Locate the absorber pad tray under the maintenance station. Remove the screws or clips holding the tray. Gently slide out the old pad. Note the sensor position so you can reinstall it correctly. Dispose of the saturated pad as chemical waste. Inspect the tray for ink crust; si présent, clean it later. Avoid touching the capping rubber with bare hands.

Installation du nouveau tampon

Clean the tray with Nocai UV cleaning solution and let it dry. Insert the new OEM pad into the tray, aligning it with the sensor and tube openings. Reinstall the tray and tighten screws lightly—do not over-torque. Reconnect any waste tubes and confirm the sensor wire is seated. Ensure the pad sits flat and the cap unit aligns with the printhead.

Counter Reset and Testing

Allumer l'imprimante. Open FlexiPRINT or the printer driver; reset the waste ink counter if your machine has this function. Run two or three cleaning cycles, puis imprimez un test de buse. All channels should fire evenly with no streaks or overflow. Check the pad area for leaks. When the test is clean, the NC-UV0406-VI ink absorber pad replacement​ is complete and the printer is ready for production.