NC-UV0609MAX-II Reemplazo de correa pequeña del eje Y

50 Vistas
Adecuado NC-UV0609MAX-II Y-axis small belt replacement​ restores stable front-back platform movement on this 600×900 mm industrial UV printer. El NC-UV0609MAX-II utiliza Epson 13200-U1 blanco, 13200-Color U1HD y barniz 11600-U1, ejecuta CMYK+LC+LM+LK+LIK+W+V a 720×600/900/1200 ppp, FlexiPRINT 22, 470W., CA 220/110 V, tinta eco UV de presión negativa, 25–28°C / 35–65% HR. The Y-axis drives the print platform; on many units this uses a screw guide, while some configurations or sub-assemblies use a small timing belt with an idler and tensioner. A loose or worn belt causes Y banding, step loss and misregistration. Fitting an OEM Nocai belt returns accurate movement.

Preparación

Apagar, desenchufe y verifique la conexión a tierra. Wear antistatic gloves and ensure good lighting. Move the platform to the front service position. Photograph the belt route, pulleys, tensioner and cable clamps. Prepare an OEM Nocai Y-axis small belt with correct tooth profile and length, hex keys, Phillips driver, tweezers and a tension gauge if available. Do not touch the printheads, encoder strip or ink lines during setup.

Remove the old belt

Loosen the tensioner until the belt relaxes. Release the belt clamp or idle pulley bracket, then slip the old belt off the motor pulley and Y pulley. Note the original routing direction. Remove the belt and inspect pulleys for worn teeth, polvo, ink mist and side wear. Clean the pulley grooves before fitting the new belt; replace the idler if it feels rough or noisy.

Install the new belt

Route the OEM belt along the original path without twisting. Seat it fully into the pulley grooves, then fit the clamp or idle pulley in the same position. Apply initial tension with the tensioner. Keep the motor pulley and Y pulley in one plane so the belt does not rub the flange. Rotate the pulley by hand to confirm smooth engagement without skipping or scraping.

Tension and test move

Adjust tension per the NC-UV0609MAX-II manual—use a tension gauge rather than finger feel when possible. Reconnect power, then jog the platform forward and backward from the panel. Movement should be smooth, with no jump, squeak or Y shift. Print a step grid and bidirectional pattern; lines must stay aligned. Stable Y tracking completes the NC-UV0609MAX-II Y-axis small belt replacement.

Cuidados posteriores al reemplazo

Recheck tension after the first hour and again after one day. Keep pulleys clean with a dry cloth, inspect the belt weekly for cracks or fraying, and lubricate guide rails per manual. Maintain 25–28°C / 35–65% HR, and use only Nocai original belts and eco UV ink.