NC-UV0609MAX-II Reemplazo del raspador

40 Vistas
Adecuado NC-UV0609MAX-II Scraper replacement​ keeps the industrial printheads clean during maintenance cycles. La NC-UV0609MAX-II imprime 600×900 mm con una altura de 0 a 180 mm, utiliza Epson 13200-U1 blanco, 13200-Color U1HD y barniz 11600-U1, ejecuta CMYK+LC+LM+LK+LIK+W+V a 720×600/900/1200 ppp, Miniservidor FlexiPRINT 22, 470W., CA 220/110 V, tinta eco UV de presión negativa, 25–28°C / 35–65% HR. The ink station includes a wiper motor, cap top, peristaltic pump and waste cartridge; the manual troubleshoots color mixing by checking whether the scraper scrapes the nozzle mirror normally during auto cleaning. Replacing a worn scraper restores even wiping and prevents banding.

Preparación

Apague y desenchufe la impresora; verificar la conexión a tierra. Use guantes de nitrilo. Open the cover and move the carriage to the maintenance position through the panel, driver or FlexiPRINT. Prepare a new genuine Nocai scraper/wiper, toallitas sin pelusa, Solución de limpieza UV Nocai, tweezers and a small driver. Photograph the wiper holder, scraper angle and cable before removal.

Removing the old scraper

Release the wiper holder screw or clip and slide out the old scraper. Inspect the rubber edge for hardening, grietas, ink cake or uneven wear. The NC-UV0609MAX-II maintenance workflow supports manual scraping, auto cleaning and nozzle test; a damaged blade that cannot wipe the nozzle mirror causes residual ink and streaking. Dispose of the old blade safely because UV ink residue is sticky.

Installing the new scraper

Fit the OEM scraper in the original orientation and align its edge parallel to the nozzle plates. Tighten the holder lightly per the Nocai manual—avoid excess pressure that bends the blade or touches nozzles. Clean the cap top and surrounding ink station with UV cleaning solution. Confirm the wiper motor can drive the scraper smoothly across all heads without obstruction.

Auto clean and nozzle test

Encendido, run Auto Cleaning in the driver or FlexiPRINT; the system executes scraping, ink washing and capping as configured. Print a nozzle test on transparent media; all CMYK+W+V channels should fire evenly. If gaps remain, clean again and retest. When output is streak-free, the NC-UV0609MAX-II Scraper replacement​ is complete and the printer is ready for production.

Post-replacement care

Wipe the scraper edge daily with UV cleaning solution, service the cap station and encoder strip per the manual, y utilice únicamente tinta original de Nocai, wiper and spare parts. Non-Nocai ink voids after-sales support. Mantener entre 25 y 28 °C / 35–65% RH for stable wiper performance.