NC-UV0609MAX-II Peristaltic pump replacement

51 Ansichten
Richtig NC-UV0609MAX-II Peristaltic pump replacement​ restores strong cleaning suction on this 600×900 mm industrial UV printer. Der NC-UV0609MAX-II druckt in einer Höhe von 0–180 mm, Verwendet Epson 13200-U1 weiß, 13200-U1HD-Farbe und 11600-U1-Lack, Läuft CMYK+LC+LM+LK+LIK+W+V mit 720×600/900/1200 dpi, FlexiPRINT MiniServer 22, 470W, Wechselstrom 220/110 V, Unterdruck-Öko-UV-Tinte, 25–28°C / 35–65 % relative Luftfeuchtigkeit. Its ink station integrates a wiper motor, Kappe oben, Schlauchpumpe und Abfallkartusche. A weak pump leaves residual ink, causes dry nozzles and poor auto cleaning. Fitting an OEM Nocai pump returns reliable suction.

Vorbereitung

Ausschalten, Ziehen Sie den Netzstecker und überprüfen Sie die Erdung. Tragen Sie Nitrilhandschuhe. Durch das Panel, Treiber oder FlexiPRINT, park the carriage at the maintenance position. Prepare an OEM Nocai peristaltic pump, matching silicone tubes, small drivers, Pinzette, Tücher, UV cleaning solution and bracket photos. Unterdruck abbauen, then label every inlet and outlet tube. Do not kink tubes or touch the printheads during setup.

Remove the old pump

Disconnect the pump cables from the board and label polarity. Loosen tube clamps, remove the inlet from the cap/wash side and the outlet to the waste bottle, then unbolt the pump head or motor bracket. Inspect rollers, silicone tube hardness, cracks and ink buildup. Replace both the pump assembly and worn tubing when suction drops, pulsates or leaks during auto cleaning.

Install the new pump

Mount the OEM Nocai pump in the original orientation and tighten the bracket evenly. Fit specified silicone tubes without twists, secure clamps, and align rotation direction per the NC-UV0609MAX-II manual. Reconnect the power cable, route wires away from the X-axis belt, Schlittenbahn und UV-Lampe. Confirm the inlet serves the cap station and the outlet reaches the waste cartridge or bottle.

Prime and cleaning test

Einschalten, Geben Sie die Standby-Wartung ein, run manual pumping until cleaning fluid and ink flow to the waste path, then run Auto Cleaning. The system executes scraping, Waschen und Verschließen der Tinte. Drucken Sie einen Düsentest auf transparenten Medien; Alle CMYK+W+V-Kanäle sollten gleichmäßig ausgelöst werden. If suction stays weak, Überprüfen Sie die Röhren erneut, direction and clamps. Stable suction completes the NC-UV0609MAX-II Peristaltic pump replacement.

Betreuung nach dem Wechsel

Inspect tubes weekly for flattening, replace silicone lines per manual, and empty the waste cartridge regularly. Wipe the cap top, wiper and encoder strip, keep 25–28°C / 35–65 % relative Luftfeuchtigkeit, and use only Nocai eco UV ink with original pump parts. Non-Nocai consumables void after-sales support.