NC-UV0609MAX-II nozzle plate replacement

16 Ansichten
Richtig NC-UV0609MAX-II nozzle plate replacement​ restores uniform ejection on this 600×900 mm industrial UV printer. Es wird Epson 13200-U1 Weiß verwendet, 13200-U1HD-Farbe und 11600-U1-Lack, druckt CMYK+LC+LM+LK+LIK+W+V mit 720×600/900/1200 dpi, FlexiPRINT 22, 470W, Wechselstrom 220/110 V, Unterdruck-Öko-UV-Tinte, 0–180 mm Höhe, 25–28 °C/35–65 % relative Luftfeuchtigkeit. OEM plates resolve streaks, banding and missing-nozzle faults.

Vorbereitung

Ausschalten, ausstecken, ground and wear antistatic gloves. Through the panel, Treiber oder FlexiPRINT, park the carriage over the cap station. Gather an OEM Nocai nozzle plate/head by BOM, screwdrivers, Pinzette, Tücher, UV cleaning solution, isopropyl alcohol and bracket photos. Unterdruck abbauen, then disconnect sacs, dampers and color lines by channel.

Diagnose and remove

Drucken Sie einen Düsentest aus; replace the plate when gaps persist after Auto Cleaning, or when scratches, baked ink, deformation, leaks or one color is fully dead. First exclude clogged tubes, faulty sacs, low pressure and dirty cap station. Disconnect the head FFC and ink fittings, unbolt the carriage block, and lift the old plate straight out without touching the nozzle surface.

Install and prime

Seat the OEM Nocai plate in the original orientation and tighten bracket screws evenly per manual. Reconnect the FFC fully, refit dampers and sacs by color, and route tubes without kinks. Set 2–3 mm head-to-media height, keep the plate parallel to the beam, and avoid overtightening. Einschalten, run manual pump and Auto Cleaning until every channel reaches the waste bottle.

Test and care

Drucken Sie einen Düsentest auf transparenten Medien; Alle CMYK+W+V-Kanäle sollten gleichmäßig ausgelöst werden. Then run step, vertical and bidirectional calibration and print an alignment grid. Bei streifenfreier Ausgabe, the NC-UV0609MAX-II nozzle plate replacement​ is complete. Daily wipe the plate with UV solution, cap heads when idle, service the cap station, and maintain 25–28°C/35–65% RH with Nocai eco UV ink.